Custom Anchor Bolts Made to Client Drawings, Delivered with Zero Rework

Custom Anchor Bolts Made to Client Drawings, Delivered with Zero Rework

A set of non-standard cast-in anchor assemblies — mixed diameters, welded base plates and special hook shapes — was produced directly from the client structural drawings. Dimensional checks were photographed and sent to the client for confirmation before galvanizing, and the goods passed acceptance on first delivery...

The assembly covers mixed diameters from M20 to M42, anchor bolts with welded base plates and several non-standard hook shapes, all produced directly from the client structural drawings with no standard catalog substitute. Every item was a made-to-print part, so the usual catalog substitution question never came up.

The process starts with a drawing review: GURONG Fastener returns a fabrication sheet marking bend radius, weld details and thread length for engineer sign-off before any bar is cut. Where a dimension conflicts with galvanizing access or weld shrinkage, the client receives an alternative proposal instead of a silent deviation.

First article parts were measured, photographed and sent for confirmation before the full batch ran. Dimensional checks were repeated after bending and welding and again before galvanizing, so the client could approve the geometry while the parts were still adjustable.

The batch passed site acceptance on first delivery with zero rework. For buyers this is the real measure of a custom order: not the quotation price, but whether the foundation pour can proceed on schedule. Drawings can be sent as PDF or STEP files and a fabrication proposal normally comes back within 48 hours.

Back to News